The treadmill has been lubricated before shipment. However, frequent check of lubricity of
the treadmill helps keep it in the best condition. The treadmill must be lubricated after one
year of use or 100 hours of running.
Each time when the treadmill is used for 30 hours or 30 days, pull up the running belt at the
side and reach out your hand to touch the surface of the treadmill as far as possible. If you
feel touching silicone oil, it is not necessary to add oil. If you feel high dryness, follow the
instructions below to apply oil.
Use non-petroleum silicone oil.
◆ Lubricating the treadmill:
①. Add oil on the surface below the running belt. (as shown in the figure below);
②. Cut a small opening on the oil bottle mouth for easy squeezing out oil;
③. Raise the running belt so that you can place the oil bottle to the bottom of the running
belt and inject oil to the middle of the running board. Put down the running belt, press
the oil filling port, and rotate the running belt to apply oil evenly on it;
④. Start the treadmill and wait one minute until oil is evenly distributed before using it.
Maintenance
Clean the treadmill frequently to extend its service life.
1. When cleaning the treadmill, be sure to pull out the power cord from the socket to shut
off the power.
2.Use a clean towel or wet cloth to wipe away sweat stains and debris from the dashboard
and other parts.
3.Do not use corrosive goods or liquids to prevent electronic components from damage. Do
not expose the electronic components to sunlight.
4.Clean up the ground once a week to remove the dirt brought by shoes and other debris.
LUBRICATING & MAINTENANCE
17
Oil bole
To Next Page
Loading...
