08
ASSEMBLY
Step 1: Lift the machine out of the package and place it on the ground. Hold the column tube
and stand it up. Apply gasket F to the knob B and then fix it at the bottom connection
of the treadmill and tighten the knobs well. Similarly, use knob C with gasket F to fix
both ends of the dashboard on the treadmill column and tighten the knobs.
Step 2: Install the red safety switch (the end of its magnet) at the place with a yellow label in the
middle below the dashboard. The installation of the machine is completed.
F
B
F
C
To Next Page
Loading...
