USCutter Titan User Manual

support for the left side
bottom stand
screw
screw
Step2
Place the stand beam upright on the T-stand and put the screws into the holes,
but do not tighten them at this step.Repeat the same steps with another stand beam.
stand beam
T-stand for right side
T-stand for left side
Floor Stand Assembly Instructions
Step1
Position the support for the left side
perpendicularly to bottom stand and
place the screws into the holes. Tighten
them to form a left side T-stand
Repeat the same steps with the support
for the right side.

USCutter Titan Specifications

General

Brand	USCutter
Model	Titan
Category	Cutter
Language	English

Summary

Floor Stand Assembly Instructions

Assemble Left and Right T-stands

Position left support perpendicularly to bottom stand, insert screws, and tighten. Repeat for the right side.

Attach Stand Beam

Place stand beam upright on T-stands and insert screws loosely. Repeat for another stand beam.

Position Roll Holder Supports

Position roll holder supports onto the floor stand and tighten the screws.

Place Roll Holders

Insert two roll holders into the designated holes in the roll holder support.

Mount Machine to Stand

Remove bottom screw from machine, insert bolt into stand top, then tighten the screw.