Utax P-C2660DN User Manual

4-59
Using the Operation Panel
AppleTalk (AppleTalk setting)
AppleTalk is a communications protocol used primarily on Macintosh
computers and also refers to the Mac OS network functions.
AppleTalk assigns 24-bit network addresses (a 16-bit network section and
an 8-bit node address) that are used to identify devices (computers,
printers, etc.) on the network.
When the power is turned on, a broadcast signal is sent out onto the
network and the addresses and machine names are automatically
assigned. The default setting is On.
1 After entering the administrator ID and password, press  or 
repeatedly until >AppleTalk appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Press  or  to select whether AppleTalk is enabled.
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
1 After entering the administrator ID and password, press  or 
repeatedly until >IPSec appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Press  or  to select whether IPSec is enabled.
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting
is Auto.
1 After entering the administrator ID and password, press  or 
repeatedly until >LAN Interface appears.
>AppleTalk
? On
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
>IPSec
? Off
Note LAN Interface is only displayed when the optional network
interface kit (IB-50) is installed.

Utax P-C2660DN Specifications

General

Brand	Utax
Model	P-C2660DN
Category	Printer
Language	English