4-79
Using the Operation Panel
Off/On (Setting toner addition notifications)
Select whether Toner Alert Level is enabled.
1 After entering the administrator ID and password, press or
repeatedly until >>Off/On appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using or .
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
TonerAlert Level (Setting for the alert level for toner addition)
This sets the level at which toner addition alerts will be displayed.
1 After entering the administrator ID and password, press or
repeatedly until >>TonerAlert Level appears.
2 Press [OK]. A blinking cursor (_) appears.
3 Press or to increase or decrease the value at the blinking cursor
and set the level at which an alert will be displayed. The setting is
possible between 005 and 100%. Use and to move the cursor
right and left.
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
To Next Page
Loading...
Need help?
General
