124124
(3) Cylinder Structure(3) Cylinder Structure
1. Fixed Pin1. Fixed Pin--TTank Locank Locatorator
5. Outlet Shut5. Outlet Shut--off Valveoff Valve
2. LPG Level Gauge2. LPG Level Gauge 6. Outlet Fitting6. Outlet Fitting--LPG HoseLPG Hose
3. Aux. Liquid Fill Valve3. Aux. Liquid Fill Valve 7. Safety Relief Valve7. Safety Relief Valve
4. Fixed Liquid Level4. Fixed Liquid Level
9. Steps for Replacing the LPG Cylinder9. Steps for Replacing the LPG Cylinder
PrecautionsPrecautions
1. 1. When replacing the When replacing the LPG cylinder, be LPG cylinder, be sure to wear sure to wear canvas gloves canvas gloves to protect from freezto protect from freeze injuries caused e injuries caused byby
leaking LPG.leaking LPG.
2. 2. When replacing the When replacing the LPG cylinder, do LPG cylinder, do so in a so in a fully-ventilated, well-lit place. fully-ventilated, well-lit place. Smoking is Smoking is strictly prohibited. strictly prohibited. AvoidAvoid
all other open flames and sources of ignition.all other open flames and sources of ignition.
3. 3. When filling with When filling with LPG cylinder, lay LPG cylinder, lay the cylinder flat the cylinder flat and set the LPG iand set the LPG inflow shut-off valve to the top. nflow shut-off valve to the top. Twist off theTwist off the
dust cover from the inflow shut-off valve. Insert the charging connector, and open the LPG inflow shut-off valve.dust cover from the inflow shut-off valve. Insert the charging connector, and open the LPG inflow shut-off valve.
When the LPG has been filled to about 80% of the tankWhen the LPG has been filled to about 80% of the tank
’’
s capacity, remove the filling head. When you fill to 80%s capacity, remove the filling head. When you fill to 80%
of rated capacity, the charge-limiting device may automatically shut down. After filling has been terminated,of rated capacity, the charge-limiting device may automatically shut down. After filling has been terminated,
remove the filling head. Twist the filling valve dust cover until tight. Tighten the inflow shut-off valve.remove the filling head. Twist the filling valve dust cover until tight. Tighten the inflow shut-off valve. Check toCheck to
make sure all components and parts are in good condition and undamaged.make sure all components and parts are in good condition and undamaged.
4. 4. Use Use the the safe safe operating procedures operating procedures per yper your lour local ocal regulations.regulations.
To Next Page
Loading...
