3535
5. Maintenance5. Maintenance
SeeSee
《《
Preventive maintenance schedulePreventive maintenance schedule
》》
forfor
further information.further information.
5.1 Daily Maintenance5.1 Daily Maintenance
1.1. Check LeaksCheck Leaks
Check LPG, electrolyte, hydraulic oil, brake fluid,Check LPG, electrolyte, hydraulic oil, brake fluid,
coolant, and oil in hydraulic transmission gear boxcoolant, and oil in hydraulic transmission gear box..
Check the engine, hydraulic pipe connector,Check the engine, hydraulic pipe connector,
radiator and driving system for leaks. DO NOT use anradiator and driving system for leaks. DO NOT use an
open flame to check levels.open flame to check levels.
!! WWaarrnniinngg
DO NOT operate truck if leaked fuel isDO NOT operate truck if leaked fuel is
found following prefound following pre--operational checks.operational checks.
Correct the leak before starting engine.Correct the leak before starting engine.
2. Check appearance2. Check appearance
Visually check the lamps and meters for problems.Visually check the lamps and meters for problems.
Check the tires, tire pressure and the entire truckCheck the tires, tire pressure and the entire truck
for loose boltsfor loose bolts
3. Check Fuel Mass3. Check Fuel Mass
A A fuel fuel level level gauge gauge is is provided provided on on the the indicatorindicator
panel. Make sure the fuel level is sufficient for thepanel. Make sure the fuel level is sufficient for the
day‘s work. The fuel filler port is located at the rear leftday‘s work. The fuel filler port is located at the rear left
pillar of the overhead guard.pillar of the overhead guard.
4. Engine Oil Level Check4. Engine Oil Level Check
!! CCaauuttiioonn
When checking the engine oil, placeWhen checking the engine oil, place
forklift on level ground, set parking brakeforklift on level ground, set parking brake
and lower forks to the and lower forks to the ground.ground.
Check engine oil when the engine isCheck engine oil when the engine is
cool.cool.
Remove the dipstick, clean the rod and reinsert. Pull itRemove the dipstick, clean the rod and reinsert. Pull it
out again and check the oil level. The level should beout again and check the oil level. The level should be
within the marks on the dipstick.within the marks on the dipstick.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
