140140
Check and Maintenance:Check and Maintenance:
（（
11
））
Check the clearance of carriage beam and below Check the clearance of carriage beam and below catch of attachment catch of attachment according to the attachment manual.according to the attachment manual.
（（
22
））
Check the rise catch is right on the flute of fork carriage.Check the rise catch is right on the flute of fork carriage.
（（
33
））
Use the auto currency lithicUse the auto currency lithic--grease per 500 hours to bearing surface.grease per 500 hours to bearing surface.
（（
44
））
Check mounting hardwareCheck mounting hardware
（（
55
））
Check the tieCheck the tie--in of hydraulic pressure loop, in of hydraulic pressure loop, if tube is damaged. Proif tube is damaged. Prohibit use until after repair.hibit use until after repair.
（（
66
））
Check the operation of attachment and replace any damaged componentsCheck the operation of attachment and replace any damaged components
（（
77
））
Check each attachment operation is functioning correctly. If not, check the hydraulic pressure loop, find out theCheck each attachment operation is functioning correctly. If not, check the hydraulic pressure loop, find out the
broken part, replace or repair part or whole loop part.broken part, replace or repair part or whole loop part.
Attachment AssemblyAttachment Assembly
!! CCaauuttiioonn
·Any change to safety or capability of attachment is strictly prohibited·Any change to safety or capability of attachment is strictly prohibited
Actual Actual load load capacity capacity should should be be the the least least of of rated rated load load capacity, capacity, attachment attachment load load capacitycapacity,,
combined load capacity of truck and attachment, combined load capacity of truck. Generallycombined load capacity of truck and attachment, combined load capacity of truck. Generally
speaking, the combined load capacity of truck is the least. Attachment load capacity may depend onspeaking, the combined load capacity of truck is the least. Attachment load capacity may depend on
attachment pressure.attachment pressure.
·Check assembly of attachment to ensure no movement on carriage·Check assembly of attachment to ensure no movement on carriage
·After hang attachment, embed the rise catch block to the gap of top beam. Ensure the center·After hang attachment, embed the rise catch block to the gap of top beam. Ensure the center
line of the attachment offset from the center line of the truck is less than 50mm. Otherwise it willline of the attachment offset from the center line of the truck is less than 50mm. Otherwise it will
affect the lateral stability of the forkliftaffect the lateral stability of the forklift
··To attachments with rotating functions, such as paper roll clamp, bale clamp, multi-purposeTo attachments with rotating functions, such as paper roll clamp, bale clamp, multi-purpose
clamp, and drum clamp, it needs to weld chock block in the joint of carriage beam and attachmentclamp, and drum clamp, it needs to weld chock block in the joint of carriage beam and attachment
to prevent movement from side to side in the operation.to prevent movement from side to side in the operation.
Assemble the lower attachment mounting to ensure correct clearance with carriage.Assemble the lower attachment mounting to ensure correct clearance with carriage.
To Next Page
Loading...
