3333
40.40. Use minimum forward and reverse tilt whenUse minimum forward and reverse tilt when
stacking and unloading loads. Never tilt forward unlessstacking and unloading loads. Never tilt forward unless
the load is over stack or at a low lift height.the load is over stack or at a low lift height.
When stacking loads on a high place, tilt the mastWhen stacking loads on a high place, tilt the mast
vertically when load is 15 to 20 cm above the groundvertically when load is 15 to 20 cm above the ground
before lifting the load further. Never attempt to tilt thebefore lifting the load further. Never attempt to tilt the
mast beyond vertical when the load is raised high.mast beyond vertical when the load is raised high.
TTo unload loads from o unload loads from a high place, insert fa high place, insert forks intoorks into
the pallet and drive backthe pallet and drive backwards, then lower the load. Tiltwards, then lower the load. Tilt
the mast back after lowering. Never attempt to tilt thethe mast back after lowering. Never attempt to tilt the
mast with the load raised high.mast with the load raised high.
41.41.DO NOT tow a truck that has engine problems, orDO NOT tow a truck that has engine problems, or
whose steering system doesn‘t work properly, orwhose steering system doesn‘t work properly, or
whose braking system has been disabled.whose braking system has been disabled.
Obey all traffic rules when towing the truckObey all traffic rules when towing the truck..
42.42. Dress appropriately for operating the truckDress appropriately for operating the truck
(overalls or other protective uniforms, safety helmet,(overalls or other protective uniforms, safety helmet,
safety shoes, etc.). Avoid wearing neckties or othersafety shoes, etc.). Avoid wearing neckties or other
articles of clothing which may present a hazard if theyarticles of clothing which may present a hazard if they
come into contact with truck components.come into contact with truck components.
43.43. The workplace should be equipped with aThe workplace should be equipped with a
firefire
extinguisher.extinguisher.In order to provide easy access to it, theIn order to provide easy access to it, the
fire extinguisher is usually installed on the safety framefire extinguisher is usually installed on the safety frame
rear supporting leg. The operator should be familiarrear supporting leg. The operator should be familiar
with position of the fire extinguisher and its use.with position of the fire extinguisher and its use.
44.44. Use a pallet, instead of the forks, when carryingUse a pallet, instead of the forks, when carrying
small goods.small goods.
45.45. There are labels on the machine that displayThere are labels on the machine that display
warnings and describe methods for operating the liftwarnings and describe methods for operating the lift
truck. When operating the machine, observe andtruck. When operating the machine, observe and
follow all markings on the machine in addition to thisfollow all markings on the machine in addition to this
operator‘s manual.operator‘s manual.
Replace damaged or missing decals and name plate.Replace damaged or missing decals and name plate.
To Next Page
Loading...
