EasyManua.ls Logo

UTILEV UT25C - Page 53

Default Icon
149 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4747
55
Start Start the the engine.engine.
66
Press the Press the brake pedal, while brake pedal, while idling. idling. Put thePut the
transmission in forward and then in reverse totransmission in forward and then in reverse to
replenish the system with fluid.replenish the system with fluid.
77
Place transmission in neutral and engagePlace transmission in neutral and engage
parking brake.parking brake.
88
Pull Pull out the dipstiout the dipstick, inspect ck, inspect fluid position.fluid position.
99
If the fluid level is insufficient, add more fluid toIf the fluid level is insufficient, add more fluid to
bring the level up to in between the maximum andbring the level up to in between the maximum and
minimum marks.minimum marks.
1010
Check the filter and drain plug for leaks.Check the filter and drain plug for leaks.
1111
Turn off the Turn off the engine, install engine, install front base plate.front base plate.
6. Air6. Air--Bleeding Fuel SystemBleeding Fuel System
DieselDiesel
During fueling or draining water from separator,During fueling or draining water from separator,
it‘s also necessary to bleed air in the it‘s also necessary to bleed air in the fuel system.fuel system.
11
Loosen the purging bolt.Loosen the purging bolt.
22
Pump the hand pump until no more air comesPump the hand pump until no more air comes
out at the purging bolt.out at the purging bolt.
33
Tighten the purging bolt.Tighten the purging bolt.
7. Drain Water from7. Drain Water from SeparatorSeparator
DieselDiesel
If If the fuel the fuel filter alarm lights filter alarm lights up while the up while the engine isengine is
running you need to drain the accumulated water.running you need to drain the accumulated water.
11
Place a container under the fuel filter.Place a container under the fuel filter.
22
Loosen Loosen the the drain drain boltbolt
W15AW15A
, then loosen the, then loosen the
drain plug by turning 4 to 5 turns.drain plug by turning 4 to 5 turns.
33
Fasten the drain boltFasten the drain bolt
W15AW15A
and plug after theand plug after the
water has been drained.water has been drained.
https://www.forkliftpdfmanuals.com/

Related product manuals