5454
（（
55
））
Raise the forklift by swinging the rod of jack untilRaise the forklift by swinging the rod of jack until
it is off of the ground. Support forklift truck by puttingit is off of the ground. Support forklift truck by putting
additional wooden blocks under each side of the frontadditional wooden blocks under each side of the front --
end frame as shown below.end frame as shown below.
（（
66
））
Take out the wheel nut of rear wheel, and thenTake out the wheel nut of rear wheel, and then
replace the wheel.replace the wheel.
!! WWaarrnniinngg
a. When removing tire from wheel rim, doa. When removing tire from wheel rim, do
not remove rim set bots and nuts beforenot remove rim set bots and nuts before
releasing air.releasing air.
b. Make sure that wooden blocks used tob. Make sure that wooden blocks used to
support lift truck are solid, onesupport lift truck are solid, one--piece units.piece units.
c. Never get under forklift while it isc. Never get under forklift while it is
supported only by wooden blocks.supported only by wooden blocks.
（（
77
））
Retighten nuts as shown in figure below:Retighten nuts as shown in figure below:
（（
88
））
Remove the wooden block under chassis body.Remove the wooden block under chassis body.
Let down the forklift slowly. Then take away the chocksLet down the forklift slowly. Then take away the chocks
before the front wheel.before the front wheel.
（（
99
））
Retighten the Retighten the wheel nut wheel nut with the with the correct correct torque.torque.
（（
1010
））
Inflate tire again to correct air pressure.Inflate tire again to correct air pressure.
3. Check Temperature3. Check Temperature
Based on the temperature, choose the suitableBased on the temperature, choose the suitable
viscosity oil.viscosity oil.
To Next Page
Loading...
