To Next PageTo Next Page
Need help?Do you have a question about the Utilitech UT175TP and is the answer not in the manual?
General| Brand | Utilitech |
|---|---|
| Model | UT175TP |
| Category | Racks & Stands |
| Language | English |
Read and understand all instructions before assembly to prevent injury or damage.
Verify all parts are present and undamaged before starting the assembly process.
Attach vertical rails to flat back panels using square washers and screws.
Secure vertical rails to curved back panels using spacers, washers, and screws.
Use spacers (LL, MM) and washers (NN) if screws are too long or for cable clearance.
Locate wood studs using a stud finder and mark mounting hole locations.
Drill pilot holes and mount wall plate using lag bolts and steel washers.
Drill pilot holes for concrete, insert anchors, and mount wall plate with lag bolts.
Hang vertical rails onto the wall plate and secure with spring locks.
Loosen tilt levers, position panel, then tighten levers to hold desired tilt.
Optionally secure the panel with a 7 mm pad lock for theft prevention.
Adjust screws on vertical rails using the built-in level for accurate positioning.
