UWE 1705N - 4.1.3 Display Segment Check; 4.1.3.1 Display Segment Check Procedure; 4.1.4 RS-232 Baud Rate Setup; 4.1.4.1 Baud Rate Options

8
dISPLAy 8.8.8.8.8.8.8.
[SET]
br SEt
br xxxxx
[SET] [ZERO] or [TARE]
br xxxxx
SEnd
[SET]
xxxxxx
[ZERO] or [TARE]
¡¾ ¡¾ ¡¾ ¡¾ ¡¾ ¡¾ ¡¾
PArity
E.7.1
[SET]
]
[ZERO] or [TARE]
n.8.1 O.7.1
4.1.3
Display segment check:¡]all segment of VFD light up¡^
4.1.4
RS-232 baud rate setup:
(300bps, 600bps, 1200bps, 2400bps, 4800bps, 9600bps, 19200bps)
Factory Default ¡G 9600bps
4.1.5
Transmission Protocol:
E.7.1: Parity = Even, Data Bit = 7, Stop Bit = 1
n.8.1: Parity = None, Data Bit = 8, Stop Bit = 1
O.7.1: Parity = Odd, Data Bit = 7, Stop Bit = 1
Factory Default ¡G E.7.1
4.1.6
RS-232 Transmission Mode:
StrEAm ¡Gcontinue transmission (Factory Default)
Auto ¡Gsend once after weight is stabled (scale has to return to zero before
sending the next weighing result)
k_Prn ¡Gmanual transmission when press PRINT
CommAnd ¡Gcommand mode, data send when computer gives commend of ¡©READ¡ª¡©CR¡ª
¡©LF¡ª
StrEAn
R E A D CR LF
52H 45H 41H 44H 0DH 0AH