Need help?Do you have a question about the V-Moda Hexamove PRO and is the answer not in the manual?
General| Type | In-Ear |
|---|---|
| Driver Size | 6mm |
| Frequency Response | 20 Hz - 20 kHz |
| Impedance | 16 Ohms |
| Microphone | Yes |
| Wireless | Yes |
| Bluetooth | Bluetooth 5.0 |
| Water Resistance | IPX5 |
| Driver Type | Dynamic |
| Connector | USB-C (charging) |
Instructions for turning the earbuds on and off by removing or placing them in the case.
Details how Hexamove Pro powers off after inactivity and can be reactivated.
Guide to automatically connect the earbuds to a device via Bluetooth for the first time.
Steps to disconnect from a previous device and pair with a new one.
Explains single, double, and triple tap functions for the right earbud's touch sensor.
Details touch control functions for the left earbud, including voice assistant access.
Instructions on inserting earbuds into the case for charging and LED indicator meanings.
Describes the audio alerts indicating remaining battery life on the earbuds.
Explains the LED indicators on the charging case for battery status with/without earbuds.
Instructions for connecting the charging case to a power source via USB-C.
Guide on how to remove and attach the interchangeable V-MODA shields.
Procedure for pairing a single replacement earbud with the existing one.
Steps to reset the earbuds to factory settings by holding the case button.
Lists causes and suggestions for failure to pair earbuds with a Bluetooth device.
Troubleshooting for issues like no sound or poor audio quality from the source.
Addresses potential latency issues where audio and video are out of sync.
Solutions for when one earbud has no sound or the audio is uneven.
Provides troubleshooting steps if the earbuds or charging case are not charging.
Guide to resolving situations where the earbuds do not respond to commands.
To Next Page
