Vacmaster SCB0501 01 - Maintenance; Cleaning Exterior

12
GB
WARNING: Remove the power cord from the power supply before carrying out any
maintenance.
1. Cleaning Exterior
1
）
Turn o󰀨 and unplug carpet cleaner.
2
）
To clean exterior, or to reduce static electricity and dust build-up, wipe outer surface with a
clean, damp and soft cloth. Wipe dry after cleaning.
2. Cleaning The Tough Stain Nozzle
It is recommended to clean the tough stain nozzle with water after each use.
1) Press the tool release button to remove the attachment from the suction hose (Fig. 18).
2
）
Pry open the cover release tab (
⑤
) on the nozzle to remove the cover (Fig. 19).
3) Rinse thoroughly with clean water. Allow the parts to dry before reinstalling.
4) Reinstall the nozzle cover back into place until a click is heard.
3. Hose Cleaning Tool
1) Remove the clean water tank and ll with warm water (Max 40°C).
2) Attach the hose cleaning tool to the suction hose (Fig. 20). Ensure any tools or attachments are
removed.
3) Make sure both the clean water and dirty water tanks are secured on the unit.
4) Press the power button to turn the carpet cleaner on and hold the spray trigger for 30 seconds
(Fig. 21). The clean water will rush through the suction hose, e󰀨ectively cleaning and removing
any trapped dirt and debris in the hose which may build up over time. Repeat as needed. Let
the machine run for 5-10 seconds before turning o󰀨.
5) Turn o󰀨 and unplug carpet cleaner.
4. Cleaning The Filter Grill
1) Remove the dirty water tank from the side of the unit.
2) Remove any dirt and debris from the lter grill (
⑥
) as shown (Fig. 22).
5. Storage
WARNING: Wrapping the power cord too tightly puts stress on the cord and could cause
damage. A damaged cord is an electrical shock hazard and could cause personal injury or
damage.
1) Replace suction hose and attachments in storage position.
2)
Wrap the power cord loosely around the cord hooks. Attach plug retainer clip onto the power cord.
3) Empty the clean water tank (if necessary). Rinse it out before replacing on the unit. Open the
clean water tank cap to allow it to air dry.
4) Empty the dirty water tank then rinse, clean and dry before placing back on the unit.
5) Store the carpet cleaner in a dry and cool indoor area.
MAINTENANCE