13
GB
2) Optionally, fully t the dust bag ange onto the inlet stub. The vacuum cleaner can we be used
with or without dust bags.
IMPORTANT: Check the lter regularly for optimal performance. An old or blocked lter will reduce
suction performance.
For Wet Vacuuming:
1) To prepare your vacuum cleaner for wet vacuuming, release the retainer lock and remove the
dry use cartridge lter.
2) Carefully install the supplied foam lter over the internal lter cage, making sure the whole cage
is covered (Fig. 14).
WARNING:
DO NOT USE THE CARTRIDGE FILTER FOR WET VACUUMING.
DO NOT USE A DUST COLLECTION BAG FOR WET VACUUMING.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely;
leave a gap at the tip of the nozzle to allow air inow. The machine is tted with a oat valve that
stops the suction action when the container reaches its maximum capacity. You will notice an
increase in motor noise. When this happens, turn off the machine, disconnect from power supply,
and drain the liquid using the drainage hose. Ensure the drainage cap is re-installed before
continuing to vacuum.
6. Blower Operation
1) Make sure the container and any collected waste is emptied before using as a blower. This also
includes removal of the dust bag.
2) Insert the locking end of the hose into the blowing port on the side of the power head (Fig. 15).
3) Turn on the motor on by turning the switch to the ‘I’ ON position.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
ONLY WORK WITH A CLEAN SUCTION HOSE. DO NOT
USE THE BLOWER FUNCTION IN AN ENCLOUSED SPACE OR FOR DUSTS
WHICH ARE HAZARDOUS TO HEALTH. DO NOT INHALE DUSTS. DO WEAR
A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
WARNING:
ONLY USE THE BLOWING FUNCTION FOR CLEANING,
REMOVING DUST, OR DRYING MACHINES AND APPLIANCES.
To Next Page
Loading...
