Vacmaster VP215 - Troubleshooting

12
Troubleshooting
VP215 will not turn on:
▫ Make sure the machine is properly plugged into a grounded
outlet.
▫ Check the power cord for tears and frays. Do not use this
machine if the power cord is damaged.
▫ Make sure the power switch is turned on. The LED screen will be
illuminated when on.
▫ If you see ‘F1’ displayed on the LED screen and the machine will
not function, make sure the lid is open and turn the power off.
Turn the machine back on and it should return to working order.
VP215 does not pull a complete vacuum with pouch:
▫ The vacuum time may not be set high enough. Set the vacuum
time higher and vacuum again.
▫ To vacuum and seal properly, the opening of the pouch must be
within the vacuum chamber. For detailed instructions, refer to
"How To Use the VacMaster® VP215 Chamber Vacuum Sealer"
on page 10.
▫ The seal bar, lid gasket and vacuum pouch need to be clean, dry
and free of debris for the vacuum process to be successful. Wipe
surface of the seal bar, lid gasket and the inside of the pouch
and try again.
Vacuum pouch loses vacuum after being sealed:
▫ Sharp items can poke small holes in pouches. To prevent this,
cover sharp edges with VacMaster® Bone Guard and vacuum in a
new pouch.
VP215 is not sealing pouch properly:
▫ The seal time may not be long enough. Increase the seal time
and try again.
▫ Pouches will not seal if any moisture, food particles or debris are
present in the seal area. Wipe the inside of the pouch clean and
try again.
▫ Pouches must be properly placed along the seal bar. Make sure
the entire pouch is over the seal bar and there are no wrinkles in
the pouch material.
ED code: This code means end of cycle. Your are ready to start a new
cycle.
If problems persist, contact customer support at
(800) 821-7849 or TechSuppotARY@aryinc.com
ARY, Inc. | 11880 College Blvd., Suite 550, Overland Park, KS 66210 | www.VacMasterFresh.com | 800-821-7849
VP215 Chamber Vacuum Sealer | User Guide