8
Adding Oil to the VP215
Required Supplies:
▫ 1/2 quart VacMaster machine oil
▫ Empty oil bottle with spout
▫ Phillips head screwdriver
▫ Adjustable wrench (not included)
1. Run vacuum process a couple
of times to "warm up" the oil.
2. Prepare the Oil: The VP215
includes a maintenance kit that
contains a 1/2 quart of oil and
an empty oil bottle with spout.
Fill the empty oil bottle with oil.
3. Remove the Back Panel: Using
the enclosed Phillips head
screwdriver, remove the four
screws from the back panel and
take the panel off the machine.
4. Remove the Oil Fill Bolt: Locate the oil ll bolt on the vacuum
pump and remove it using an adjustable wrench or similar tool.
5. Fill the Pump with Oil: Insert the spout into the open hole (oil
ll bolt opening) and begin pouring the oil into the pump. Fill the
pump until the oil level is at 1/2 to 3/4 in the site glass. This is
approximately 10 to 12 ounces of oil.
6. Replace the Oil Fill Bolt and Back Panel: Once the pump is lled
with oil, screw the oil ll bolt back in place and put the back panel
on the machine. The VP215 Chamber Vacuum Sealer is now ready
for use.
Required oil change schedule:
First Change: one week after use.
Future Change: every 3 months or 250 cycles, which ever comes rst.
VP215 Setup
Back of
Housing
Cabinet
Oil Fill Bolt
Oil Site Glass
ARY, Inc. | 11880 College Blvd., Suite 550, Overland Park, KS 66210 | www.VacMasterFresh.com | 800-821-7849
VP215 Chamber Vacuum Sealer | User Guide
To Next Page
Loading...
