9
VP215 Setup
How to Use
Please read all instructions before operating the VP215
1. Attach the power cord and plug the machine into a grounded
electrical outlet - Properly insert the electrical cord into the
power outlet on the back of the machine and then plug the cord
into the wall outlet.
2. Open the machine lid - Release the lid lock, located on the right
side of the machine, and allow the lid to lift and remain open.
3. Turn the power switch on - Turn
the red switch on the left side of
the machine toward the front,
switching from the "0" to the
"1" position. The LED Screen on
the control panel will illuminate
showing a symbol.
IMPORTANT: Do not turn the machine on until the lid lock has been
released. The lid lock feature is used ONLY to keep the lid closed
while the machine is in storage.
Adjusting the VP215 Timing Controls
NOTE: Timing adjustments must be made with the lid lock off and the lid open.
To adjust/set the timing controls, press the SET button on the control panel
until the required label (Vacuum, Sealing or Cooling) is illuminated. For
each selection, the current time setting will show on the LED Screen. All
time settings are displayed in seconds.
For initial testing, the time settings should be:
Vacuum Time: 40 seconds
Sealing Time: 1.2 seconds
Cooling Time: 2.2 seconds
To change the timing control settings, please read "Adjusting the VP215
Timing Controls" on Page 7.
ARY, Inc. | 11880 College Blvd., Suite 550, Overland Park, KS 66210 | www.VacMasterFresh.com | 800-821-7849
VP215 Chamber Vacuum Sealer | User Guide
To Next Page
Loading...
