10
How to Use
Adjusting the VP215 Timing Controls (Cont’d)
Vacuum Time: To increase or decrease the vacuum time, press the SET
button until VACUUM is illuminated and then use the UP/DOWN buttons
to adjust the vacuum time accordingly. The time setting will display on
the LED Screen on the control panel.
NOTE: Filler plates can be used to reduce the vacuum time required. Place
the filler plates inside the chamber as desired. Filler plates occupy space,
leaving less air to be removed from the chamber. If you require more space
inside the chamber, remove the filler plates to accommodate your product.
Sealing Time: To increase or decrease the sealing time, press the SET
button until SEALING is illuminated and then use the UP/DOWN buttons
to adjust the sealing time to accommodate your application. It is
recommended that you make adjustments in 0.1 second increments to
avoid melting the pouch.
NOTE: For thicker pouches, you should increase the seal time in 0.1 second
increments until the pouch seals completely. In addition, for thinner pouches,
you should decrease the seal time in 0.1 second increments to avoid over-
sealing the pouch.
Cooling Time: To increase or decrease the cooling time, press the SET
button until COOLING is illuminated and then use the UP/DOWN buttons
to adjust the cooling time accordingly.
NOTE: The VP215 settings will always default to the most recently used
settings on the machine.
Mpa
Mpa
Mpa
Mpa
Vacuum Cycle
Runs for a set time - counting down to zero
Sealing Cycle
Runs for a set time - counting down to zero
Cooling Cycle
Runs for a set time - counting down to zero
Lid Release
Indicates the end of the process
ARY, Inc. | 11880 College Blvd., Suite 550, Overland Park, KS 66210 | www.VacMasterFresh.com | 800-821-7849
VP215 Chamber Vacuum Sealer | User Guide
To Next Page
Loading...
