13
Cleaning & Storage
▫ Disconnect the power cord from the electrical outlet by unplugging it.
Do not disconnect by pulling on the cord.
▫ Do not immerse in water or spray directly with liquid.
▫ Check the Vacuum Chamber and Gasket, making sure they are clean
and free of debris. If needed, use a clean, damp cloth with mild soap.
a. Wipe the vacuum chamber clean.
b. Wipe the gasket clean.
c. Wipe the seal area clean.
▫ Do not store the VP215 outside.
▫ 65°-75° recommended operating temperature.
▫ Do not use any acetone-based or abrasive cleaners on the lid or other
plastic parts. Only clean lid with a damp cloth and mild soap.
▫ Elevation: High elevation m ay cause the gauge to not fully go into
the green.
Maintenance Kit
1. Double Sided Tape: Used for adhering the
top bar that holds the seal pad in the lid.
2. 15-Amp Fuses (2x): Can be used for
replacing fuses located on the control
transformer and the cord receptacle.
NSF models will have a fuse on the seal
transformer.
3. Seal Wire: Used to replace seal wire that
spans the length of the seal bar; should
be replaced if the wire shows heavy
discoloration.
4. Seal Tape: Used to replace seal tape the
covers the seal wires; should be replaced if
the tape shows heavy discoloration, is torn,
or is starting to lose the adhesive.
5. Oil Fill Bottle: Used to ll pump with oil.
6. Hex/ Allen Wrench: Used to removed
tension blocks that hold the seal wire to
the base of the seal bar.
7. #1 Screwdriver: Used to un-thread screws
on the cabinet of the machine and the
screws to move the chamber.
1
2
3
4
5
7
6
ARY, Inc. | 11880 College Blvd., Suite 550, Overland Park, KS 66210 | www.VacMasterFresh.com | 800-821-7849
VP215 Chamber Vacuum Sealer | User Guide
To Next Page
Loading...
