Vacmaster VP321 - Adding Oil to Vacuum Pump

4
ARY, Inc. | 5200 W 110th Street Suite 200, Overland Park, KS 66211 | www.VacMasterFresh.com | 800-821-7849
VP321 Chamber Vacuum Sealer | User Guide
Stop!
Read and complete the following to prevent any damage.
Oil must be added to the vacuum pump before using.
VacMaster
®
model VP321 uses an oil vacuum pump.
For shipping purposes there is no oil in the pump. Oil must be added.
Adding Oil to Vacuum Pump
Turn off and unplug machine to prevent electrocution.
1. Using the included ARY approved oil, fill the enclosed plastic oil bottle.
2. Locate the oil fill bolt (A) on the top of the vacuum pump.
3. Remove oil fill bolt.
4. Watching oil site glass (B) insert end of oil bottle into hole.
5. Fill oil level between 1/2 to 3/4 of site glass.
• Donotoverfill.Overfillcancausedamagetothevacuumpump.
6. Replace and tighten bolt to vacuum pump.
NOTE:Pumprequiresapproximately8fluidouncesofoil(approx.1cup).
 UseonlyapprovedVacMaster
®
vacuumoil.
A. Oil Fill Bolt
Side of Cabinet
Housing
B. Oil Site Glass