and outside before storage. REMEMBER! The foam filter must be removed after wet
vacuuming, and a cartridge filter must be installed before dry vacuuming again.
This Wet/Dry Vac has blowing capabilities. To use the
blower feature follow the instructions listed.
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS. WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
6.1. Verify that the power cord is disconnected from the outlet.(fig. 1)
6.2. Make sure the container is empty before using as a blower.
6.3. Remove hose from the vacuum port
6.4. Insert the locking end of the hose into the blowing port on the back side of the power
head and lock into position.(fig. 2)
6.5. Fit the desired extension wand or nozzle to the vacuum hose.(fig.3)
6.6. Ensure the power switch is turned off and plug in the power supply. (fig. 4)
6.7 Before turning on the vac, firmly hold loose end of the hose. Turn the motor on by
flipping the switch to the ‘I’ ON position.(fig. 5)
To Next Page
Loading...
