Vacon 100 INDUSTRIAL - Page 20

4
vacon • 18 Installation
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
7
The bus termination must be set for the first and the last device of the fieldbus
line. See picture below. See also step 3 on page 17. We recommend that the first
device on the bus and, thus, terminated was the Master device.
Fieldbus cable
= Bus termination
Termination
activated
Termination
activated with
jumper
Termination
deactivated
Vacon 100 Vacon 100 Vacon 100 Vacon 100 Vacon 100
3007.emf