How to resolve 'Start-up prevented' error on Vacon Inverter?
If the Vacon Inverter displays 'Start-up prevented', it means the start-up of the drive has been prevented because the run request is ON when a new application is loaded to the drive. Cancel prevention of start-up if this can be done safely, or remove the run request.
What to do if my Vacon Inverter shows an undervoltage error?
If the Vacon Inverter displays an undervoltage error, it means the DC-link voltage is below the fault voltage limit, possibly due to low supply voltage, an internal fault, or a broken input fuse. In case of a temporary supply voltage break, reset the fault and restart the frequency converter. Check the supply voltage, and if it's adequate, an internal failure may have occurred. Also, check the input fuses and the DC charge function.
What to do after changing a device type on a Vacon Inverter?
After changing an option board or power unit to a different type or rating on your Vacon Inverter, reset the system. Set the option board parameters again if an option board was changed, and set the converter parameters again if the power unit was changed.
What should I do after adding a different type of option board to my Vacon Inverter?
After adding an option board of a different type to your Vacon Inverter, reset the system and then set the option board parameters again.
What does an unbalance warning mean on a Vacon Inverter?
An unbalance warning on a Vacon Inverter indicates an unbalance between power modules in paralleled units. Should the fault re-occur, contact your local distributor.
What to do if the cooling fan of my Vacon Inverter isn't working?
If the cooling fan of the Vacon Inverter does not start when the ON command is given, contact your local distributor.
What to do after changing a device of the same type on a Vacon Inverter?
After changing an option board or power unit to a new device of the same type and rating on your Vacon Inverter, reset the system. The device is then ready for use, and the old parameter settings will be used.
What should I do after adding the same type of option board to my Vacon Inverter?
After adding an option board to your Vacon Inverter, reset the system. The device is ready for use, and the old board settings will be used.
What does an EEPROM checksum fault mean on a Vacon Inverter?
An EEPROM checksum fault on a Vacon Inverter indicates a parameter save fault, faulty operation, or component failure. Should the fault re-occur, contact your local distributor.
What to do if my Vacon Inverter displays a microprocessor watchdog fault?
If your Vacon Inverter displays a microprocessor watchdog fault, it could be due to faulty operation or component failure. Reset the fault and restart. Should the fault re-occur, contact your local distributor.
Symbols used for safety and damage warnings in the manual.
Marks and symbols on the product and their meanings.
Essential safety guidelines for inverter installation and operation.
Proper earthing and earth fault protection requirements and methods.
Specifications for Vacon 8000 Solar models: power, dimensions, efficiency.
Detailed technical parameters: input/output, environment, protection, and communications.
Procedures for mounting and securing the inverter cabinet.
Overview of electrical schematics for various Vacon 8000 Solar inverter models.
Instructions for connecting cables, including earth and mains connections.
Steps and diagrams for connecting the inverter to the mains power supply.
Instructions for connecting solar panel cables to the inverter's DC input.
Details on connecting control signals and option boards to the inverter.
Guide to identifying and resolving common faults and alarms for the inverter.
To Next Page
General
