Vacon NXV0040 - Page 14

14 • vacon INSTALLATION
Tel: +358-201-2121 • Fax: +358-201-212 205
4.2.2 Fixing the unit to floor and wall
For additional stability, the cabinet can also be mounted to the floor and the back wall. To accom-
plish this, follow this procedure:
1. On the bottom of the cabinet, remove the screws of the rear iron clamp. Flip it and refix the
screws as shown in
Figure 4-5.
2. Then bolt the cabinet to the floor at the fixing points on the bottom front side, see Figure 4-5.
BOTTOM VIEW
FRONT
REAR
Rear iron clamp
Figure 4-5.
3. Use the fixing points at the top rear side of the cabinet to bolt it to the back wall. See Figure 4-6.
TOP VIEW
REAR
FRONT/TOP VIEW
FRONT
Figure 4-6.
Welding of the cabinet might risk sensitive components in the converter.
Ensure that no grounding currents can flow through any part of the converter.