VAF instruments Shapoli 620 - Page 20

19
Figure 13 – ShaPoLi home screen when Shaft power is
above EEXI limit
Figure 14 – ShaPoLi home screen when communication with
Power sensor is lost
Figure 15 – ShaPoLi home screen when NMEA
communication with SDB-3 is lost
Figure 16 – ShaPoLi home screen when one of the expected
power sensors have not been enabled
Figure 17 – ShaPoLi home screen when there is a
communication failure of an individual sensor. Only if using
an analog power sensor (Torque, Speed or Power)
Figure 18 – ShaPoLi home screen when encrypted ShaPoLi
settings are missing
Figure 19 – ShaPoLi home screen when IO communication
is lost
When two power sensors are connected and one sensor has a failure, the Power sensor number is also
shown in the red bar. More detailed information can be viewed in submenu Alarms.
These alarms can be silenced and/or accepted. This will be explained in chapter 7.5.3.