VAF instruments Shapoli 620 - Signals

24
NOTE:
Alarms can only be silenced / accepted via the VAF Bridge Panel PC!
7.5.4 Signals
Within the Signals menu you can monitor the raw signals coming in from the different sensors, connected
to the SDB-3:
- Power sensors → Torque, Speed and Power from T-Sense
®
, TT-Sense
®
or 3
rd
party
Torque meters
- GPS values → NMEA ship data
- Analog inputs → 4-20mA signals of a 3
rd
party Torque meters
In the Signals menu you will notice that the output values from the faulty sensor are changed to “0” and
are coloured red.
Figure 27 – Signals menu – Power sensor information
(Modbus or 4-20mA analog signals)
Figure 28 – Signals menu – NMEA ship data
Figure 29 – Signals menu – Analog 4-20mA signals
(Torque, Speed, Power)