20
8. MAINTENANCE
No special maintenance is needed for the PEM4 touch screen.
The touch screen can be cleaned with a dry and clean cloth.
Do not use any cleaning product or chemical on the screen.
9. REPAIR
Nothing on the PEM4 touch screen can be repaired on site.
10. TAKE OUT OF SERVICE
Switch off the power supply.
11. REMOVAL AND STORAGE OF EQUIPMENT
Switch off the power supply.
Make sure that all wires that are connected to the PEM4 are labelled correctly so that re-installation of
the PEM4 can be done without any errors. Disconnect all the input and output wires.
Store the PEM4 in a box in a cool and dry place, so that the PEM4 cannot be damaged.
12. MALFUNCTION AND SEND FOR REPAIR
If the PEM4 stops working completely contact VAF Instruments for instructions.
VAF Instruments is working with a RMA (return material authorisation), in the event the PEM4 has to be
sent back for repair, you can contact VAF Instruments, by email: service@vaf.nl
for further instructions.
13. ENVIRONMENT
The PEM4 touch screen has no negative influence on the environment during normal operation.
14. DISPOSAL
The PEM4 touch screen is made out of metal and electronics. It should be disposed according to local
laws of the country.
To Next Page
Loading...