16
7.5.2 Propulsion screen
Figure 8 – Propulsion screen
This page is showing the average propulsion data over the last 1, 4 and 24 hours. When the propeller
shaft is rotating the PEM4 is continuously recalculating these average values. In case the propeller
shaft is not rotating the average values stay as they are.
“Total Energy” consumed by the propeller and the “Total Revolutions” made by the shaft are available
at the lower part of the screen.
The “Total Energy” value jumps from kW to MW to GW (min. 0,000 kW and max. 9999 GW).
The “Total Revolutions” value jumps from E3 to E6 to E9 (respectively 1000, 1x10
6
and 1x10
9
revolutions).
These total values can be set to zero anytime by pushing the “Reset” buttons.
After resetting “Total Energy” and “Total Revolutions” the previous displayed values are
lost.
7.5.3 Settings menu
Figure 9 – Settings menu
This “Settings Menu” is accessible by entering the 4-digit password 1234 in the login screen. This
screen is your entrance to adjustment of settings.
To Next Page
Loading...