9
Fault diagnosis:
The device V-DCS3 the time to be fed with electricity, check the status of the sensors continu-
ously. If any of the sensors has a problem or the cable is then cut on the screen shows the mes-
sage << Error >> next to the corresponding sensor (See page 6 example display 2).
CAUTION: For safety reasons, if a fault is detected in the collector sensor or sensors collectors
(application 4), the relay or relays (application 4) circulators will be activated and the relay R2
applications 2 and 3 will be disabled.
Sensors & Accessories:
Immersion Sensor (+180 ° C) V-KTY 50 with 50cm cable length and
diameter cup 6mm. The type of cable is 2x0, 50mm silicone.
Immersion Sensor (+180 ° C) V-KTY200 with cable length 2 m and di-
ameter cup 6mm. The type of cable is 2x0, 50mm silicone.
The VAGEO HVAC products designed and manufactured in Greece
by INTELCO Electronics PELEKIS E. & Co.
Christos Karvouni 27 Ta.K.136 71 Axarnai Attica
T.+30 2102323345 F.+30 2102386382
vageo@intelco.gr www.intelco.gr - www.vageo.gr
To Previous Page
Loading...