Operation
14 Operating instructions ecoTEC pro 0020129673_00
5
5.3.1 Setting the hot water temperature
45
5.5 Setting the hot water temperature
> Press the left-hand selection button (" ").
The domestic DHW temperature that is set is shown flash-
ing on the display.
> Use the minus button
or the plus button
to change the domestic hot water tempera-
ture.
> Confirm the change by pressing the right-hand selection
button
(“ ”).
If you have connected an eBUS auto controller to the boiler,
you can set the DHW target temperature on the controller.
> Ask your approved skilled tradesman whether an eBUS
auto controller is connected.
If you are using an eBUS auto controller:
> Set the hot water temperature on the boiler to the maxi-
mum possible temperature.
> Set the desired hot water temperature (hot water target
temperature) on your controller.
5.3.2 Activating/deactivating Comfort mode
Comfort mode immediately supplies you with hot water at
the required temperature, without you having to wait for
the water to heat up. To do this, the plate-type heat
exchanger of the ecoTEC pro is kept at your selected tem-
perature level.
Comf.
on
5.6 Switching Comfort mode on and off
> Press the left-hand selection button (" ").
> Press the right-hand selection button
("
").
"Comf.on" or "Comf.off" are shown flashing in the display.
> Use the minus button
or the plus button
to activate or deactivate Comfort mode.
> Confirm the change by pressing the right-hand selection
button
(“ ”).
When you have activated Comfort mode, the symbol "
" is
shown in the basic display.
When you have deactivated Comfort mode, the symbol "
"
goes out in the basic display.
5.4 Setting a room thermostat or weather
compensator
2
1
5.7 Setting the room temperature controller/weather controlled
regulator
> Set the room thermostat, weather compensator (1) and
thermostatic radiator valves (2) as specified in the oper-
ating instructions for these accessories.
To Next Page
Loading...
