4 Operating and installation instructions 0020288151_04
1 Safety
1.1 Action-related warnings
Classification of action-related warnings
The action-related warnings are classified in
accordance with the severity of the possible
danger using the following warning signs and
signal words:
Warning symbols and signal words
Danger!
Imminent danger to life or risk of
severe personal injury
Danger!
Risk of death from electric shock
Warning.
Risk of minor personal injury
Caution.
Risk of material or environmental
damage
1.2 Intended use
In the event of inappropriate or improper use,
damage to the product and other property
may arise.
The product is intended for using an eBUS
interface to control a heating installation with
heat generators from the same manufacturer.
The system control controls based on the
installed system:
– Heating
– Cooling
– Ventilation
– Domestic hot water generation
– Circulation
Intended use includes the following:
– observance of accompanying operating,
installation and maintenance instructions
for the product and any other system com-
ponents
– installing and setting up the product in ac-
cordance with the product and system ap-
proval
– compliance with all inspection and main-
tenance conditions listed in the instruc-
tions.
Intended use also covers installation in ac-
cordance with the IP code.
This product can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabil-
ities or lack of experience and knowledge if
they have been given supervision or instruc-
tion concerning use of the product in a safe
way and understand the hazards involved.
Children must not play with the product.
Cleaning and user maintenance work must
not be carried out by children unless they are
supervised.
Any other use that is not specified in these
instructions, or use beyond that specified in
this document, shall be considered improper
use. Any direct commercial or industrial use
is also deemed to be improper.
Caution.
Improper use of any kind is prohibited.
1.3 General safety information
1.3.1 Qualification
Work and functions that must only be car-
ried out or set by the competent person are
marked by the symbol.
The following work must only be carried out
by competent persons who are sufficiently
qualified to do so:
– Set-up
– Dismantling
– Installation
– Start-up
– Decommissioning
▶ Proceed in accordance with current tech-
nology.
1.3.2 Batteries
▶ Note the battery type, as described in
these instructions; see section "Data
plate".
▶ Remove and insert batteries as described
in these instructions; see section "Chan-
ging the batteries".
▶ Do not recharge non-rechargeable batter-
ies.
▶ Remove rechargeable batteries from the
product before charging them.
▶ Do not combine batteries with other battery
types.
▶ Do not combine new and used batteries.
To Next Page
Loading...
Need help?
General
