Setting up AP10
1 Touchscreen.
2 Ethernet cable. Use a shielded cable to
meet the rated EMC performance of
the device.
3 Cable from DC power supply.
• AP10 requires a network connection to your viewLinc Enterprise Server and a
Network Time Protocol (NTP) server. AP10 can also use its default NTP servers
if Internet is accessible from the network.
• It is usually easiest to configure the access point before mounting it.
1. Connect the Ethernet cable to Ethernet port of AP10. If possible, connect to the same
network where the viewLinc Enterprise Server is, so that you can verify the connection
when doing the setup.
2. If the Ethernet cable does not provide power, connect the DC power supply:
a. Connect the plug to the power supply connector of AP10. Make sure the plug is
oriented correctly and goes in all the way. Rotate the plug to lock it in, otherwise it
will not stay reliably connected.
b. The power supply comes with multiple adapters for wall sockets. Connect the adapter
you need, and plug in the power supply to a wall socket.
5
ENGLISH
To Next Page
Loading...
Need help?
General