3'4, USe Of
the Heat
Shiglding
mat
..........
o. o. o.... o o......
use the heater on combustible flooring
un-
less the heat
shielding
mat, which is avail-
able
as an option,
is
used.
,r
The heater
operates within the voltage range
.
of 108 Volts to 132 Volts. Before
plugging
the
i,
healer into the
generator,
the output voltage
''
of
generator
should
be
verified.
Heat shielding mat
3-5. Operation
With Portable
generator.
o.....................
Before
operating
the heater from
a
portable
generator,
please
confirm that the
generator
has been
properly
connected to the
ground
earth. To operate the
generator
without
proper
grounding
may result in electrical
shock.
Please refer
to the owner's manual supplied by
the
generator's
manufacturer.
lf the voltage
does
not measure in this range,
the heater should not be
plugged
into the
gen-
erator.
lnspection
.
Never
inspect
or service the heater while it is burning, in operation, hot or
plugged-in
to
avoid any injury and/or trouble.
Before starting any inspection or service, to avoid electric
shock,
please
make
sure
the
heater is
shut down and that the
power
cord is disconnected.
When cleaning the heater,
please
wear
gloves
to
prevent possible
injury.
Observations
.
Please do not
pour
in the
fuel
tank the fuel used
for
cleaning
the tank inlet filter
;
after
you
finish to inspect inside the fuel
tank,
please
do not return back into the fuel tank
foul
fuel
taken
out
ofthe tank.
4-1 . Daily InSpeCtiOn
. . . . . . . . . . . . . . o . . . . . . . . .
. . .. . . . . . . . o . . . . . .
I Inspection
of
the
tank
inlet
filter
Please remove
the fuel cap and check if
dirt/
dusts stick to the tank inlet filter.
lf there are
any dirt/dusts,
remove
the
filter
and
wash it with
fuel.
,
,ffi
ffi
firmly
the
fuel
cap.
Please restore the tank inlet filter,
and
tighten
Tank Inlet Filter
To Next Page
Loading...