i Switch Section
Operating Switch
This ignites or extinguishes the flame.
(Refer
to
pages
8 and 9.)
Operating
Lamp
This is lit while
(the
heater is) operating and flashes while
(the
heater is) cooling down.
Misfire Lamp
This
flashes
when the
flame is
extinsuished.
Description
of Devices
@
Flame Monitor
This
automatically extinguishes
the flame when ignition fails or flame
goes
out during
the
operation.
This monitor, when
detects any
irregularity be-
fore ignition, automatically extinguishes the
flame.
Operating Condition: Misfire lamp flashes and
Post-Purge
continues
for three
(3)
minutes.
@
Electric
Overload
System
(Fuse)
This shuts
off
the
power
supply
when excessive electric current
passes
through,
due
to irregular trouble
of
the
devices.
Operating Condition:
The whole
operation stops.
,^!.
ffiEl
Howro
use
3-1.
Preparation for
thg Operation
.......o...................o
.
Never use
highly
flammable fuel like
gasoline,
to avoid fire.
Please refuel
only while
the heater is
turned off
and completely extinguished.
Please use only the
electric
power
(voltage
and
frequency
specified on
the model
plate
).
Such electric
power
as different
from
the specificartions
may result in fire, electrical
shock and/or damage.
Please
confirm the
ground/earth
cable is surely connected, to
prevent
electrical shock.
For disconnecting the electric
power, pull
always the
plug
out. Also, do not
pull
and bend
with excessive force the cord. not to damase it and to have a fire or electrical shock.
I Refueling
Observations
Make
sure
that the tank inlet filter
(in
the
fuel
tank)
is free of dirt/dusts,
etc.
If the filter is filled up with dirt/dusts, take out
the
filter and
wash it with
kerosene.
Do not
pour
back into the fuel tank the kerosene
used for
washing,
to avoid troubles.
I
HowTo
Use
To Next Page
Loading...
