37
EN
Useful information
C
2. Remove the nuts from the water inlet hoses to access the
filters on the water inlet valves. Clean them with a suitable
brush. If the filters are very dirty, remove them with pliers
and clean them.
3. Remove the filters from the flat ends of the water inlet
hoses and the seals and clean them thoroughly with tap
water.
4. Carefully replace the seals and lters and tighten the nuts
by hand.
Removing the remaining water and cleaning the pump lter
• Your machine's filtration system prevents solids such as
buttons, coins, and fabric fibres from clogging the pump
impeller as the washing water drains. This ensures that the
water is drained off without any problems and extends the
life span of the pump.
• If your machine does not drain the water, this means the
pump lter is clogged. The lter should be cleaned whenever
it becomes clogged or every 3 months. The water must be
drained rst to clean the pump lter.
• Before transporting the machine (e.g. moving it from one
house to another) or if the water freezes, it may be necessary
to drain the water completely.
To Next Page
Loading...
