Valcom V-1060B User Manual

INSTALLATION
Connections
Two conductor twisted wire is required for the 45
ohm talkback speakers. Standard 22 or 24 gauge
station wire is acceptable. Shielded wire is not
required or recommended. Connections are as
follows:
• Speaker out from page control to speaker tip.
• Speaker common to speaker ring.
• Switched –24 Vdc to –24 Vdc (LED).
• Power supply Ground to GND (LED).
Mounting
V-1060B: Cut an 8.5" dia. hole in ceiling tile. After
connections have been made to the speaker, attach
speaker to ceiling tile using the mounting hardware
provided. NOTE: Where extra speaker support is
needed, a V-9916 or V-9916M Valcom Bridge and
Backbox should be used.
V-1062B:
After making the required connections,
fasten a suitable mounting screw (#10 sheet metal
screw or similar) to the wall at the desired location
for mounting of the speaker. Hang the speaker on
the screw using the keyhole on the speaker bracket.
V-1064B:
After making the required connections to
the speaker, use appropriate hardware such as an 8d
finishing nail and hang the speaker in the corner.
Typical mounting height would be 8 feet.
V-1066B:
Unscrew mounting bracket and baffle
from speaker assembly. Using appropriate hardware,
mount the bracket to the wall. After making the
required connections, reattach the baffle to the
speaker and the speaker to the mounting bracket.
TECHNICAL ASSISTANCE
When trouble is reported, verify the unit is properly
connected and there are no broken connections
leading to this unit.
Assistance in troubleshooting is available from the
factory. When calling, you should have a volt-ohm
meter and a lineman's test set and be calling from the
job site. Call (540) 427-3900 and ask for Technical
Support, or (540) 427-6000 for Valcom 24-hour
Automated Support or visit our website at
http://www.valcom.com.
Valcom equipment is not field repairable. Valcom,
Inc. maintains service facilities in Roanoke, VA.
Should repairs be necessary, attach a tag to the unit
clearly stating company name, address, phone
number, contact person, and the nature of the
problem. Send the unit to:
Repair and Return Dept.
Valcom, Inc.
5614 Hollins Road
Roanoke, VA 24019-5056
TROUBLESHOOTING CHART
SYMPTOM ACTION
• No sound in page mode. • Check tip and ring for audio at speaker.
• Check tip and ring for audio at control unit.
• Low sound in page mode. • Check volume controls at page control.
• Poor listening in talkback
mode.
• Check talkback volume control at page control. Set
control where audio is clearly audible.
• No LED indication. • Check presence and polarity of LED input signal.
3 947067

Valcom V-1060B Specifications

General

Brand	Valcom
Model	V-1060B
Category	Speakers
Language	English