Valetine One V1 User Manual

23
BOB, The Brown-Out Booster
To save fuel, some newer cars automatically switch off the engine instead of
idling. As they restart, power to accessories momentarily drops below V1’s
10-volt minimum, causing it to repeat its start-up sequence when voltage is
resumed. BOB (optional) solves the problem by maintaining voltage during
these brief sags. BOB has two RJ11 (telephone) jacks. Run a power cord from
the source of 12V to the jack labeled “To 12V.” Plug power cord from V1 into
the jack labeled “To V1.”
BOB is an electronic device that doesn’t use a battery and requires no periodic
service. Dimensions: 1.0-in H x 1.7-in W x 1.2-in D; Weight: 0.5 ounces.
Install according to one of the following diagrams:
Remote Audio Adapter
Lighter Adapter
Valentine One
L
ighter Adapter
Concealed Display
Main
Acc
Main
Acc
Power Out
Main Unit
T
o 12VTo V1
To 12VTo V1
To 12VTo V1
T
o 12VTo V1
#3
#4
R
emote Audio Adapter
Power Out Power In
Brown-Out
Booster (BOB)
D
irect-wire
Power Adapter
Concealed Display
Power In
Main Unit
Acc
Valentine One
P
ower Out
B
rown-Out
Booster (BOB)
#2
Valentine One
Brown-Out
Booster (BOB)
Valentine One
Brown-Out
Booster (BOB)
Direct-wire
Power Adapter Remote Audio Adapter
Power Out Power In
Concealed Display
Acc
Power In
Remote Audio Adapter
#1
• NOTE: Remote Audio Adapter does NOT control power to V1.
• NOTE: Remote Audio Adapter does NOT control power to V1;
but it will turn the Concealed Display off and on.
• NOTE: Remote Audio Adapter controls power to V1.
• NOTE: Remote Audio Adapter controls power to V1.

Valetine One V1 Specifications

General

Brand	Valetine One
Model	V1
Category	Radar Detector
Language	English