Valmar 3255 - New Product Calibration

Calibration Valmar
Page
20
storage position on the inside left hand
corner of the hopper as shown in Figure
5-2.
Figure 5-2: Calibration Crank Storage
8. Install the crank on the shaft indicated in
Figure 5-3. Turn the crank in the
direction indicated until product is falling
evenly across the entire width of
metering rollers. The product must
meter out from the bottom of the roller
not the top.
9. Empty both collection containers into the
hopper. Measure and record the weight
of each empty container.
Figure 5-3: Calibration Crank
Calibration Procedure
1. Set the gearbox to the desired speed as
shown in the Operation section of this
manual.
2. Turn the crank the number of turns
indicated in the following table.
Implement Width (ft.)
No. Of Crank Turns
30 123
32 115
34 108
36 102
38 97
40 92
42 88
44 84
46 80
48 77
50 74
52 71
55 67
60 61
65 57
70 53
75 49
80 46