53
7.3 PUSH-BUTTON PANEL (PRODUCTION – COOLING)
7.3.1 KEYS (cylinder – cooling part)
7.3.1.1 key START
7.3.1.1.1 START with the START CYCLE BUTTON on the PUSH-BUTTON PANEL
The START CYCLE button is always set to one of the menu programs
(except when first using the machine).
1. Press the button to display the set NEW
program or the LAST program used.
2. Press START CYCLE again to start the
program (NEW or LAST).
3. Program screen.
All menu programs are started with the START CYCLE button .
The end of the cycle is notified by a beep and a light signal (if any). A message
is displayed to take out the ice cream. Should the operator not take out the ice
cream after the notice, the machine will keep ice cream consistency
automatically until extraction, i.e. until the end of the maximum time limit.
In all DUAL machines you can with START CYCLE button set to one of the
menu programs (heating or cooling).
To Next Page
Loading...
Need help?
General
