USERS INSTRUCTIONS
SAFETY
IF YOU SMELL GAS
DON'T SMOKE
EXTINGUISH ALL NAKED FLAMES
DON'T TURN ELECTRICAL SWITCHES ON OR OFF
TURN OFF THE GAS SUPPLY AT THE METER
OPEN DOORS AND WINDOWS TO GET RID OF THE GAS
IMMEDIATELY CALL THE GAS EMERGENCY SERVICE - SEE YOUR LOCAL TELEPHONE DIRECTORY
1. As with any gas appliance, this fire must be installed 6. Never put any paper or other material on the fire.
by a competent person. In the United Kingdom, Never add any extra coals abovethe number stated
installation must be in accordance with the latest in these instructions. This could cause a safety
edition of the GasSafety (installation
&
use) hazard.
Regulations. In the Republic of Ireland, installation 7. It should be appreciated that although this appliance
must be in accordance with all national and local conforms to all the applicable standards, it is a
regulations in force. decorative fuel effect heating appliance and certain
2. If the fire is intended to be installed to a chimney parts of its surface will become hot. A suitable guard
which was previously used for solid fuel, please which complies with SS 6539 or 6778 should be
note that the chimney must be swept prior to used for the protection of young children, the elderly
installation. and the infirm. Such a guard is also recommended
3. On no account must the fire stand on carpets or for the protection of pet animals.
other combustible materials. The fire must stand 8. Always switch the fire off and allow to cool before
behind a non-combustible hearth surface. The handling. Note that this appliance retains heat for
hearth material must be at least 12mm thick. Its top some time after it has beenswitched off.
surface should be 50mm above floor level to 9. Never hang clothing, towels or any other fabrics over
discourage placing carpets. the fire.
Rugs or other combustible materials over the 10. This appliance is fitted with an Oxysafedevice which
hearth. will automatically shut off the supply of gas to the
The minimum size of the hearth is shown in figure 1. fire if, for any reason, the flames go out. If this
4. If the fire is intended to be installed against a wall device does operate or if the fire is turned off
with combustible cladding, the cladding must be accidentally or intentionally, always wait three
removed from the area covered by the outer minutes before attempting to relight.
surround. 11. Soft wall coverings (e.g. embossed vinyl etc.), are
5. The minimum height from the top surface of the easily affected by heat. They may,therefore, scorch
hearth to the underside of any shelf made from wood or become discoloured when close to a heating
or other combustible material and which is not more appliance.
than 150mm deep is 818mm. For shelves deeper Pleasebear this in mind when having a heating
than 150mm add 12.5mm to the above clearance for appliance installed and when redecorating.
every 25mm of additional shelf depth.
Please note
When operating your fire for the first time, some vapours may be given off which may cause a slight odour and could possibly set off any smoke alarms in the immediate vicinity. These vapours are quite
normal with new appliances. They are totally harmless And will disappear after a few hours use.
This fire is supplied with ceramic "coals" to simulate a real coal fire. These items are designed for easy refitting if removed. After some use, the coals may change colour. This is quite normal.
Page 4
To Next Page
Loading...
Need help?
General
