Need help?Do you have a question about the Valor BR and is the answer not in the manual?
General| Brand | Valor |
|---|---|
| Model | BR |
| Category | Indoor Fireplace |
| Language | English |
Details legal requirements and industry standards for gas appliance installation in the UK and Ireland.
Outlines acceptable installation scenarios, including fireplace types and flue configurations.
Lists all components included in the appliance packaging and advises checking for completeness and condition.
Verifies the satisfactory operation of the piezo electric spark ignition system before installation.
Assesses the fireplace for flatness, sound attachment points, and suitability for flue box installation.
Ensures adequate flue draught using a smoke test as per BS5440: Part 1.
Details the procedure for connecting the gas supply pipe through the rear of the convection box.
Instructions for detaching the front surround from the convection box.
Guidance on removing the burner unit from the convection box.
Securing the convection box to the fireplace surround using screws.
Alternative installation using tension cables and floor fixings for stability.
Applying floor sealing tape to seal the bottom of the convection box to the fireplace floor.
Performing a pressure check on the pipework for gas soundness.
Initial checks on pilot ignition, low/high burner settings, and shut-off operation.
Placing the ceramic rear wall into the back of the fire box.
Positioning the front base coal halves in the burner compartment.
Inserting the rear base coal behind the front coal.
Reconfirming pilot and main burner operation after fuel effects are in place.
Testing for flue spillage using a smoke match tube.
Verifying the operation of the automatic gas shut-off system.
Instructions for fitting the fire front casting to the front surround.
Advising the customer on how to operate the appliance safely.
Advising regular servicing and chimney inspection for safety.
Step-by-step guide for replacing burner plaques and associated components.
Procedure for detaching the front surround for servicing or part replacement.
Instructions for detaching and removing the entire burner unit.
Detailed steps for removing the pilot unit assembly.
Procedure for removing the gas tap and flame supervision device.
Steps to remove the piezo ignition generator unit.
Guidance on removing the main burner injector.
To Next Page
