6
Fig 2 Pack contents
2.17 Propane gas appliances must not be installed in a
room, which is built entirely below ground level
(see BS 5871 Part 2).
.
3. UNPACKING
The pack contains:
1 Burner & Convection box Unit
1 Front surround unit
1 Nut & olive for 8mm inlet pipe
1 Ceramic back wall
1 Pair of ceramic side walls
1 Front base coal- left & right halves
1 Rear base coal
1 Pack of 5 loose coals
2 Small “U” seals for convection box side flanges
1 Strip of floor sealing tape
1 Flue restrictor plate
6 Fibre plugs
4 Woodscrews
2 Fire retaining cables
2 Cable clamps
4 Eyebolts
1 Installation template
1 Smoke match tube
1 Fire front casting
1 Bottom front cover casting
1 Literature pack
Carefully remove the contents. Take special care in handling
the ceramic walls and the coals.
Check that all the listed parts are present and in good
condition.
(b) Twin walled metal flue box
(Internal dimensions)
* If internal width is greater than 440mm,
the opening width must be reduced to
not more than 440mm to ensure
adequate sealing to fire.