11. CONVECTION BOX INSTALLATION 26
11.1 Method 1 - Front fixing to fireplace surround. 26
11.2 Method 2 - Cable retention and floor fixing. 26 - 27
11.3 Sealing floor front - Method 1 & 2 inc Frameless 28
12. FITTING THE WALL LINERS & FUEL EFFECT 29
12.1A Fitting the Single piece rear wall liner (Ceramic/Glass) 29
12.1B Fitting the Two or Three piece rear wall liners (Vermiculite) 29
12.2 Fitting the Glass liners spacer support and filler piece. 29
12.3 Fitting the side wall liners (Vermiculite/Ceramic/Glass. 29
12.4 Fitting the log fuel effect 30
13. BURNER AND SUPPLY PIPE INSTALLATION 30
13.1 Burner installation. 30
13.2 Supply pipe installation. 30
13.3 Burner checks. 30
- 13.3.1 Lighting the fire (RC) 30
- 13.3.2 Adjusting flame height (RC) 31
- 13.3.3 Adjusting to pilot only (RC) 31
- 13.3.4 Turing off (RC) 31
- 13.3.5 Lighting the fire (FS) 31
- 13.3.6 Adjusting flame height (FS) 32
- 13.3.7 Turning off (FS) 32
13.4 Check inlet pressure. 32
14. REASSEMBLE OF FIRE 33
14.1 Fitting the bottom tray into convector box 33
14.2 Fitting the top tray into the convector box 33
14.3 Positioning the ember wool accross the burners 33
14.4 Replacing the log fuel effect 34
14.5 Refit the window door panel 34
14.5 Refit the visual baffle 34
15. FULL OPERATING CHECKS 34
15.1 Check the burner operation. 34
15.2 Check for spillage. 34
15.3 Flame supervision and spillage monitoring system. 35
16. TRIM OR FRAMELESS INSTALLATION 36
17. FINAL REVIEW 37
© GDC Group Ltd. NOV 2017
Page 6
Continued on next page
CONTENTS (Continued)
Section Page
To Next Page
Loading...
Need help?
General
