ValueHD VHD-V61 - IR Remote Control Overview; Power & Position Buttons; Setting and Clearing Presets; Backlight Compensation Button

To Next Page

To Previous Page

ValueHD Corporation

IR Remote Controller Explanation

0. Standby Button

Press this button to enter standby mode. Press it

again to enter normal mode.

(Note: Power consumption in standby mode is

approximately half of the normal mode)

1. Position Buttons

To set preset or call preset

2. * Button

3. Set/Clear Preset Buttons

Set preset: Store a preset position

[SET PRESET] + Numeric button (0-9): Setting a

corresponding numeric key preset position

Clear preset: Erase a preset position

[CLEAR PRESET] + Numeric button (0-9)

Or: [*]+[#]+[CLEAR PRESET]: Erase all the

preset individually

4. BLC (Backlight Compensation) Button

BLC ON/OFF: Press this button to enable the

backlight compensation. Press it again to disable

the backlight compensation.(NOTE: Effective

only in auto exposure mode)

Note: If a light behind the subject, the subject will