ValueHD VHD-V61 - Restore Default and System Configuration; Factory Default Restoration

ValueHD Corporation
28
according to the agreement, AUTO, VISCA protocol
Optional items: 1 ~ 7
P_D_Address: PELCO-D protocol Optional
items: 0 ~ 254
P_P_Address: PELCO-P protocol Optional
items: 0 ~ 31
V_AddrFix: If I can change through the serial
port of infrared switch, Optional items: On, Off
（When set to On, useless in 88 30 01 FF
Command）
Net Mode: Set the serial port control
networking, Optional items: Serial, Paral
Baudrate: Serial port baud rate. Optional items:
2400, 4800, 9600
8. RESTORE DEFAULT
Move the cursor to the Restore Default item in
the main menu and press [home] button, RESTORE
DEFAULT menu appears, as shown in the following
figure.
Restore: Confirm restore factory settings.
Optional items: Yes, No
Note: Press [HOME] button to confirm, All
parameter restore default, Include IR Remote
address and VISICA Address
Save: Save Options. Optional items: Yes, No
RESTORE DEFAULT
Restore? No
Change Value
[Home] OK
[Menu] Back