Van's Aircraft RV-12 Manual

PAGEREVISION:DATE:
VAN'S AIRCRAFT, INC.
F-1201A
Step 4: Cleco the F-00027-L & -R Com Supports to the
F-1202B Panel base as shown in Figure 3.
Match-Drill #30 the most forward hole in each com support into
the panel base as shown in Figure 3.
Remove the com supports and deburr the match-drilled holes in the panel base.
Step 5: Attach the F-00026-L & -R Inst Stack Angles and the F-00027-L & -R
Com Supports to the F-1202B Panel Base using the rivets called-out in Figure 3.
FIGURE 2:
INST STACK ANGLE
NUTPLATE INSTALLATION
F-00026-L
K1000-06,
TYP
AN426AD3-3.5,
TYP
NOTE: This page only applies if installing the AV GARMIN SL40 Com Radio.
Step 1: Separate the F-00026 Inst Stack Angle into F-00026-L & -R Inst Stack Angles as shown in Figure 1.
FIGURE 1:
SEPARATING THE
INST STACK ANGLE
Step 2: Machine countersink all the .098 diameter holes in the F-00026-L & -R
Inst Stack Angles to fit the head of an AN426AD3 rivet. See Figure 2 to
determine which surface to countersink.
Step 3: Install nutplates on the F-00026-L & -R Inst Stack Angles in the
locations shown in Figure 2. Note that there are two locations on each inst
stack angle which do not have nutplates installed.
F-00026-R
REMOVE
HATCHED
AREA
F-00026-L
07/24/13
LP4-3,
TYP
FIGURE 3:
INST STACK ANGLE
& COM SUPPORT
INSTALLATION
DATE:
CLECO
HERE
MATCH-DRILL
HERE
F-1202B
F-00026-L
RV-12
REVISION:
1
42D-09
F-00027-R
F-00027-L
F-00026-R

Van's Aircraft RV-12 Specifications

General

Brand	Van's Aircraft
Model	RV-12
Category	Aircrafts
Language	English