Vanderbilt SPCE652.100 - 17.11 Configuring Communications

displayed.
If request is approved, a new license key is issued.
3. Enter the new key in the field provided.
17.11 Configuring Communications
This section covers:
17.11.1 Communications Settings 295
17.11.2 FlexC® 304
17.11.3 Reporting 323
17.11.4 PC Tools 335
17.11.1 Communications Settings
This section covers:
l Configuring the networking services of the panel below
l Ethernet on the facing page
l Configuring Modems on page297
l Serial ports on page303
17.11.1.1 Configuring the networking services of the panel
1. Select Communications > Communications > Services.
The following page will be displayed.
2. Configure the fields as described in the table below.
HTTP
Enabled
Tick this box to enable the embedded web server on the panel.
HTTP Port Enter the Port number that the web server is 'listening' on. By default this is set
to 443.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 295 A6V10276959-d
11.2018