VANDERSTEEN 3A - Packing Instructions

Packing The Model 3A
Packing Instructions
To prevent physical or cosmetic damage, always
pack the Model 3As in their original boxes prior to
transportation or shipment. Please follow these instruc¬
tions when packing a Model 3A.
1. T urn off the amplifier and disconnect the speaker
cables from the speaker.
The open area of the end trays must
always face away from the speaker.
V___ J
2. Turn the speaker upside-down on a folded towel or
carpeted surface and remove the rear brace and
cones.
3. With the speaker still up-side-down, pull the plastic
bag down over the speaker.
4. Slide the cardboard inner liner over the speaker.
5. Fit one of the end trays into the end of the inner liner
with the open area of the end tray facing away
from the speaker.
6. Holding the flaps out, slide the outer box over the
inner liner all the way to the floor.
7. Carefully turn the box right-side-up.
8. Close the plastic bag and place the remaining end
tray into the inner liner as was done in step 5.
9. Close the flaps on the outer box and seal with strong
tape.
10. Put the cones and brace mounting bolts into a
plastic bag and tape the bag to one of the braces for
safe keeping.
r \
Do not attempt to ship your
speakers in anything other than an
original specification box. New
boxes and packing are available
from Vandersteen Audio for a
nominal charge.
V___ J
\| End Tray \/
f
Fold
VANDERSTEEN AUDIO
116 West Fourth St.
Hanford, CA 93230
(559) 582-0324
www.vandersteen.com
Vandersteen Audio, Inc.
14